Removal Procedure
- Slide the front seat all the way forward.
 
- Remove the seat belt from
  the seat belt guide located on the side of the bucket seat.
 
- Remove the cover from the shoulder belt guide to expose the bolt.
 
- Remove the retaining bolt from the shoulder belt guide adjuster
  bracket.
 
- Remove the left inside garnish molding. Refer to
Center Pillar Garnish Molding Replacement - Left Side 
in Interior Trim.
 
- Remove the body side front lower molding. Refer to
Body Side Front Lower Trim Panel Replacement 
in Interior Trim.
 
- Remove the electrical connectors.
 
- Remove the bolt retaining  the retractor from the pillar, lift
 upward to release.
 
- Remove the retractor from the vehicle.
 
Installation Procedure
- Install the retractor to the vehicle.
 
Notice: Refer to Fastener Notice in the Preface section.
- Install the retractor  bolt to the pillar.
 
Tighten
Tighten the retractor bolt to the pillar to 53 N·m (39 lb ft).
- Install the electrical connectors.
 
- Install the body side front lower molding. Refer to
Body Side Front Lower Trim Panel Replacement 
.
 
- Install the left inside garnish molding. Refer to
Center Pillar Garnish Molding Replacement - Left Side 
.
 
- Install the bolt retaining
  the shoulder belt guide to the adjuster bracket.
 
Tighten
Tighten the shoulder belt retaining bolt to 30 N·m (22 lb ft).
- Install the cover to the shoulder belt guide.
 
- Install the seat belt to the seat belt guide located on the side
  of the bucket seat.
 
- Slide the front seat back in position.