For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category |
DTC Descriptor
DTC B2462 00: Global Positioning System Sensor Receiver FailureDTC B2462 08: Global Positioning System Sensor Signal Invalid
Circuit Description
The navigation antenna is connected to the navigation module with a coax cable. The navigation module polls the data from the navigation antenna once every second.
Conditions for Running the DTC
| • | The ignition ON |
| • | The system voltage is at least 9.5 volts and no more than 15.5 volts. |
Conditions for Setting the DTC
| • | GPS antenna output above threshold. |
| • | General GPS receiver error during test. |
Conditions for Clearing the DTC
| • | The navigation module detects a proper signal from the GPS antenna. |
| • | A history DTC clears after 50 fault-free ignition cycles. |
Reference Information
Schematic Reference
Radio/Navigation System Schematics
Connector End View Reference
Description and Operation
Navigation System Description and Operation
Electrical Information Reference
Circuit/System Testing
- Ignition OFF, disconnect the GPS coaxial cable from the navigation module.
- Ignition ON, test for 4-5.5 volts between the center conductor and the shield of the coaxial cable.
- If all circuits test normal, replace the GPS antenna.
| ⇒ | If not within the specified range, replace the navigation module. |
Repair Instructions
Perform the Diagnostic Repair Verification.
| • | Control Module References for navigation module replacement, setup, and programming. |
