Removal Procedure
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Reference mark the propeller shaft to the rear axle pinion yoke.
- Reference mark the propeller shaft to the transmission or transfer case.
- Remove the bolts and the yoke retainers from the rear axle pinion yoke.
- Slide the propeller shaft forward in order to disconnect the propeller shaft from the rear axle pinion yoke.
- Slide the propeller shaft rearward in order to disconnect the propeller shaft from the transmission or transfer case.
- Remove the propeller shaft.
Important: Observe and accurately reference mark all driveline components relative to the propeller shaft and axles before disassembly. These components include the propeller shafts, the drive axles, the pinion flanges, the output shafts, etc. All components must be reassembled in the exact relationship to each other as they were when removed. In addition, published specifications and torque values, as well as any measurements made prior to disassembly must be followed.
Notice: When removing the propeller shaft, do not attempt to remove the shaft by pounding on the yoke ears or using a tool between the yoke and the universal joint. If the propeller shaft is removed by using such means, the injection joints may fracture and lead to premature failure of the joint.
Installation Procedure
- Inspect the splines of the slip yoke for a sufficient coating of grease/lubricant. If the splines of the slip yoke does not have a sufficient coating of grease/lubricate, lubricate the shaft with P/N 12377985.
- Install the propeller shaft into the transmission or transfer case.
- Install the propeller shaft to the rear axle pinion yoke.
- Install the yoke retainers and the bolts.
- Lower the vehicle.
Align the reference marks made during removal.
Align the reference marks made during removal.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the bolts to 20 N·m (15 lb ft).
