1. Support the vehicle drive axle on a suitable hoist. Refer to Lifting and Jacking the Vehicle.
2. Remove the tire and tire assembly from the drive axle. Refer to Tire and Wheel Removal and Installation.

Warning: Refer to Work Stall Test Warning in the Preface section.

3. Reinstall the wheel nut to fix the brake disc.
4. Drive the vehicle at the concern speed and inspect the presence of vibration at the same time.

Caution: Do not depress the brake pedal with the brake rotors and/or the brake drums removed, or with the brake calipers repositioned away from the brake rotors, or damage to the brake system may result.

5. If the vibration is still present, remove the rotors from the drive axle and then run the vehicle back to the concern speed. Refer to Rear Brake Rotor Replacement.
6. If the vibration is eliminated when the brake rotors are removed from the drive axle, repeat the test with one rotor installed at a time. Replace the rotor that is causing or contributing to the vibration concern. Refer to Rear Brake Rotor Replacement.



7. If a brake rotor was replaced following the previous steps or the result obtained during the previous steps need to be confirmed, and/or check the components other than the drive axle, perform the following steps:

7.1.	Mount the brake rotor onto the balancer in the same manner as a tire and wheel assembly does.

Note: Only check brake rotors for static imbalance, ignore the dynamic imbalance.

7.2.	Inspect the brake rotor for balance.

There is not a set tolerance for brake rotor static imbalance. However, any brake rotor measured in this same manner which is over 21 g (¾ oz), may have potential to cause or contribute to a vibration. Rotors suspected of causing vibration should be replaced. Inspect the replacement rotor for imbalance in the same manner.